Figure 8-29 Type Of Service Window - NEC Univerge SV9100 Manual

Figure 8-29 Type of Service Window

8-42
Enter Values on a Per Phone Basis
By the web browser

By configuration mode through the dial pad

To enter the values per phone, browse to the individual phone or enter the
configuration mode through dial pad.
The following example describes assigning these fields via the web browser.
1. Log in on PC. Refer to Section
2. Go to Network Settings>Advanced Settings>Type Of Service.
3. There are two choices: RTP and SIP. RTP = voice packets and SIP =
signaling packets.
Select each field and assign the appropriate value. Then select OK.
These fields are also looking for a Hexadecimal value as with command 84-
23. Refer to Table 8-2 Common IP Precedence/Diffserv Values and
Hexadecimal Equivalent on page
15.3.1 Logging In on the PC on page
8-41.
IP Multiline Station (SIP)
Issue 2.0
8-30.