Table 8-1 Ip Phone Programming Options User Menu - NEC Univerge SV9100 Manual

Issue 2.0
Programming - GCD-CP10:
10-12-01: GCD-CP10 Network Setup - IP Address
10-12-10: GCD-CP10 Network Setup - Subnet Mask
10-12-03: GCD-CP10 Network Setup - Default Gateway
10-12-09: GCD-CP10 Network Setup - IP Address
( This assignment is for GCD-CP10 when the GPZ-IPLE daughter
board is installed. )
Programming - GPZ-IPLE:
84-26-01: IPL Basic Setup - IP Address (Slot # - DSP)
Programming - IP Phones
DHCP Mode:
IP Address:
Subnet Mask:
1st Server Address
1st Server Port
S 9 IP P
ECTION
This section describes how to access the programming interface for IP phones. To
access the User Menu follow the steps listed below.
1.
2.
SV9100 Networking Manual
(for GCD-CP10)
P
HONE ROGRAMMING
Using a DT800/DT700 telephone, press the Menu button to enter program
mode. The IP User Menu is displayed.
On the IP User Menu, select Config (0) for the IP Phone. Settings are listed in
Table 8-1 IP Phone Programming Options User

Table 8-1 IP Phone Programming Options User Menu

Programming Option
UserName
Password
I
NTERFACE
Menu.
Default
ADMIN
6633222
0.0.0.0
255.255.255.0
198.168.1.254
192.168.1.20
192.168.1.21
Disabled
192.168.2.200
255.255.255.0
198.168.1.20
5080
8-13