NEC Univerge SV9100 Manual page 262

3-6
The Network Administrator (or IT Manager) should provide the following:
IP Address (for the GCD-CP10 blade)

IP Addresses (for the GPZ-IPLE)

Subnet Mask

Default Gateway

Range(s) of IP Addresses to assign

List of permanent IP addresses, with corresponding MAC Addresses

A spare switch/hub port

Figure 3-3 Example Configuration 2 - New Network with Dynamic Addressing
DHCP Client
Server
(should always have
192.168.1.32 assigned)
Now connect the UNIVERGE SV9100 GPZ-IPLE Ethernet Port to the switch/hub
port, using a standard CAT-5 patch cable. The UNIVERGE SV9100 is now
configured on the network and its DHCP server is ready to allocate IP addresses.
The client PCs should be set to Obtain IP Address Automatically. Refer to
3-4 TCP/IP Properties Screen on page
Router
(Default
Gateway)
192.168.1.254
Switch
(Switched Hub)
DHCP Client
DHCP Client
3-7.
Issue 2.0
WAN,
Internet, etc.
UNIVERGE SV9100
Chassis with GCD-CP10
Installed
192.168.1.200
Figure
General IP Configuration