NEC Univerge SV9100 Manual page 266

S 2 H
ECTION OW TO
To enter programming mode:
1.
2.
3.
4.
5.
4-2
The second row of the display KY01 = *01 indicates that Key 01 is being
programmed with the entry of *01. The third row allows you to move the cursor to
the left or right, depending on which arrow is pressed.
To learn how to enter the programming mode, refer to
Programming Mode below.
E P
NTER ROGRAMMING
Go to any working display telephone.
 In a newly installed system, use extension (port 1).
Do not lift the handset.
Press Speaker.
#  # 
Password
Dial the system password + Transfer.
Refer to the following table for the default system passwords. To change the
passwords, use 90-02 : Programming Password Setup.
User
Password
Name
---- ----
12345678 tech
0000 ADMIN1
9999 ADMIN2
M
ODE
Level Programs at this Level
1 (MF) Manufacturer (MF):
All programs
2 (IN) Installation (IN):
All programs in this section not listed below for SA
and SB
3 (SA) System Administrator - Level 1 (SA):
10-01, 10-02, 10-12, 10-13, 10-14, 10-15, 10-16,
10-17, 10-18, 10-22, 12-02, 12-03, 12-04, 15-01,
15-07, 15-09, 15-10, 15-11, 20-16, 21-07, 21-14,
22-04, 22-11, 25-08, 30-03, 32-02, 40-02, 41-02,
41-03, 41-04, 41-05, 41-06, 41-07, 41-08, 41-09,
41-10, 41-11, 41-12, 41-13, 41-14, 41-15, 41-16,
41-17, 41-18, 90-03, 90-04, 90-06, 90-07, 90-18,
90-19
4 (SB) System Administrator - Level 2 (SB):
13-04, 13-05, 13-06
Issue 2.0
Section 2 How to Enter
Programming