Park - NEC Univerge SV9100 Manual

Issue 2.0

3.24 Park

Park
Park places a call in a waiting state (called a Park Orbit) so that an extension user may pick it up. Any
extension user who is in the same Park Group as the extension which placed the call in Park can answer
the call. This includes extension users in a networked system. For example, when an extension user in
Park Group 3 within System A places a call in Park, the extension users in Park Group 3 at any connected
system can retrieve the call by pressing the flashing park key or dialing a service code.
If you do not want the park hold orbits to be available to other users within the AspireNet network, then
place the extension at each site in a different park hold group in Program 24-03.
With a single system, when two users within the same Park Group try to place a call in the same park orbit
at the same time, one user will get the orbit while the other user's call will either ring back or it will remain
an active call, depending on how the park orbit was accessed. With Networking, if both users try to access
the same orbit, one user will get the orbit, while the other will hear ringback, at which time they can park the
call in a different orbit.
Operation
To Park a call in a system orbit:
You can Park Intercom or trunk calls.
1. Press Park key (PGM 15-07 or SC 752: *04 + orbit).
The Park key LED lights.
If you hear busy tone, the orbit is busy. Try another orbit.
2. Use Paging to announce call.
3. Press SPK to hang up.
If not picked up, the call will recall to you.
OR
1. At system phone or 2-Button telephone, press HOLD.
OR
At a SLT single line telephone, hookflash.
2. Dial #6 and the Park orbit (01-64).
If you hear busy tone, the orbit is busy. Try another orbit.
3. Use Paging to announce call.
4. Press SPK to hang up.
If not picked up, the call will recall to you.
Note: The parked call recalls after the Park Hold Time (Program 24-01-06). The call rings the extension to
which it recalled for the Hold Recall Callback Time (Program 24-01-02). The call then goes on Hold for the
Park Hold Time - then recalls again for the Hold Recall Callback Time. The call continues to cycle between
Hold and recall until the extension user answers the call or the outside party hangs up.
To pick up a parked call:
1. Lift handset.
2. Press Park key (PGM 15-07 or SC 752: *04 + orbit).
OR
At single line telephone, lift handset.
1. Dial *6 and the Park orbit (1-64).
SV9100 Networking Manual 13-43