Sv9100 Pcbs - NEC Univerge SV9100 Manual

Hide thumbs Also See for Univerge SV9100:
Table of Contents

Advertisement

Paging
AspireNet allows a user to place Paging call to a networked system. If you need to get through to a co-
worker who is not at their desk then place a paging call to their system.
Call Forwarding
You can forward your calls to an extension at another networked extension. If you visit another site
within your network but forgot to set a call forward then use Follow Me to have your calls forwarded to
you. Follow Me is also useful if you have an DECT handset. If your handset is subscribed at the site
you are visiting then you can use Follow Me to have your calls forwarded to your DECT handset.
Direct Dial In(DDI)
A DDI call can be routed to any extension within the network. This allows an extension to receive a
DDI call from any other system in the network. Along with trunk access it is possible for an extension
on a system that has no trunk lines to use the trunks of another system in the network.
Trunk Access
An extension can access a trunk line at another system in the network. The user dials the standard
trunk access code and the system will automatically route the call to the system that has trunks
connected.
Conference
An extension can have a conference call that includes co-workers at another system within the
network.
1.2

SV9100 PCBs

There are two methods available for AspireNet connection as shown in the following table.
ISDN AspireNet
Using ISDN AspireNet the system provides up to 256 B-channel ports which can be used for
Networking.
A PRIA circuit will take 30 ports and each BRI circuit will take 2 ports.
These ISDN AspireNet ports are independent of the trunk and station ports available on the system.
IP AspireNet
Using IP AspireNet the maximum quantity of simultaneous calls is limited by the availability of
resources on the IPLE PCB's installed. A PZ-IPLE PCB's giving a maximum of 256 speech channels.
The maximum quantity of calls may also be reduced by the compression mode (CODEC type) of the
IPLE PCB's, this is selectable by the installer in Program 84-12-28.
13-2
Interface
ISDN
Using Q.931 based proprietary protocol,
Basic rate interface and Primary rate
interfaces are available.
VoIP
Using H.323 protocol for voice transmit
protocol.
Description
Issue 2.0
Note
A PRIA or BRIA Blade is
required for connection.
An IPLE daughter board is
required.
AspireNet

Advertisement

Table of Contents
loading

Table of Contents