NEC Univerge SV9100 Manual page 677

Entering two digits lets you define codes based on the first two digits a user dials. For example, entering

60 allows you to define the function of all codes beginning with 60. In the default program, only
use 2-digit codes. All the other codes are single digit. If you enter a two digit code between 0 and 9, be
sure to make separate entries for all the other two digit codes within the range as well. This is because
in the default program all the two digit codes between 0 and 9 are undefined.

Defining codes based on more than 2 digits require a secondary program (PRG 11-20) to define the codes.
Step 2: Specify the length of the code you want to change
After you specify a single or two digit code, you must tell the system how many digits comprise the code.
This is the Number of Digits Required column in the
page 1-91 table.
Step 3: Assign a function to the code selected
After entering a code and specifying its length, you must assign its function. This is the Dial Type column
in the Table 1-4 System Numbering Default Settings on page 1-91
Dial
Types
13-82
Dial Type Description
0 --- Not Used ---
1 Service Code
2
Extension Number
3 Trunk Access Code
4 Special Trunk Access
5 Operator Access
6
ARS/F-Route Access
8
Networking System
Access
Table 1-4 System Numbering Default Settings on
table. The choices are:
Related Program
11-10 : Service Code Setup (for System Administrator)
11-11 : Service Code Setup (for Setup/Entry Operation)
11-12 : Service Code Setup (for Service Access)
11-13 : Service Code Setup (for ACD)
11-14 : Service Code Setup (for Hotel)
11-15 : Service Code Setup, Administrative (for Special
Access)
11-16 : Single Digit Service Code Setup
11-02 : Extension Numbering
11-04 : Virtual Extension Numbering
11-06 : ACI Extension Numbering
11-07 : Department Group Pilot Numbers
11-08 : ACI Group Pilot Number
11-17 : ACD Group Pilot Number
11-09-01 : Trunk Access Code
11-09-02 : Trunk Access Code
20-17 : Operator Extension
44-xx
Issue 2.0
and
#

AspireNet