NEC Univerge SV9100 Manual page 709

Hide thumbs Also See for Univerge SV9100:

Table of Contents

Use Program 14-06 : Trunk Group Routing to set up an outbound routing table for the trunk groups

you assigned in Program 14-05. When users dial 9, the system routes their calls in the order (priority)

specified. For example, if a user dials 9 and all calls in the first group are busy, the system may route the

call to another group. Trunk Access Map programming (Programs 14-07) may limit this option. The

system contains 100 routing tables for trunk access. Each table has four priority orders for trunk access.

There are 100 available Trunk Group Numbers.

Program 14 : Trunk, Basic Setup

Example for setting:

With less than four trunk groups,

Route Number 1

: Order 1 – Trunk Group 1

: Order 2 – Trunk Group 2

For the above setting, if all the lines in trunk group 1 are busy, the system searches

for an idle line in trunk group 2.

With more than four trunk groups,

Route Number 1

: Order 1 – Trunk Group 1

: Order 2 – Trunk Group 2

: Order 3 – Trunk Group 3

: Order 4 – 1002 (Jump To Route Number 2)

Route Number 2

: Order 1 – Trunk Group 4

: Order 2 – Trunk Group 5

For the above setting, if all the lines in the trunk groups 1, 2 and 3 are busy, the

system searches for an idle line in trunk groups 4 and 5.

14-06 : Trunk Group Routing