NEC Univerge SV9100 Manual page 662

Issue 2.0
Item
No.
11
12
13
14
15
16
17
18
19
20
SV9100 Networking Manual
Item
Networking System Number
(Network Mode only)
--- Not Used ---
Loss-Of-Signal Detection Limit
If the transmit/receive voltage is less
than the setting in 10-03-13, the system
considers this as Loss-Of-Signal and
the PRTA does not come up. Note that
there are different values based on the
setting in 10-03-12 for the PRI.
Service Protocol for S-point
Call Busy Mode for S-point
Two B-Channel Transfer for PRI
Service
ISDN Ringback Tone
If Telco does not provide ringback tone,
SV9100 can if 10-03-17 is set to
1:Enable.
Type of Number
ISDN Protocol definition.
Select the number type for the ISDN
circuit.
Numbering Plan Identification
ISDN Protocol definition.
Select the Numbering Plan used for the
ISDN circuit.
Network Exchange Selection
Select the ISDN protocol for the ISDN
circuit.
Input Data
0 - 50
0 =Level 0 (lowest sensitivity)
1 =Level 1
2 =Level 2
3 =Level 3
4 =Level 4
5 =Level 5
6 =Level 6
7 =Level 7 (highest sensitivity)
0 =Keypad facility
1 =Specified Protocol for Aspire
system
0 =Alerting
1 =Disconnect
0 =off
1 =on
0 =Disable
1 =Enable
0 =Unknown
1 =International number
2 =National number
3 =Network Specific number
4 =Subscriber number
5 =Abbreviated number
0 =Unknown
1 =ISDN numbering plan
2 =Data numbering plan
3 =Telex numbering plan
4 =National standard numbering
plan
5 =Private numbering plan
0 =Standard (same as NI-2)
1 =reserved
2 =reserved
3 =DMS (A211)
4 =5ESS
5 =DMS (A233)
6 =4ESS
7 =NI-2
Default
0
2
0
0
0
0
0
0
0
13-67