Checking The Firmware Version - NEC Univerge SV9100 Manual

14.2 Checking the Firmware Version

14.3 Upgrading Automatically
8-24
8. To select download by file, press option 1 (Download File).
9. To boot the program, press 3 (Boot Program).
10. Press the softkey.
The IP Phone downloads the firmware from the FTP/TFTP server and reboots
when the download is complete.
To check the IP Phone firmware version:
1. Press and hold the Help button on the System IP Phone.
2. To access information, press 8 (System Information).
3. To display the firmware version, press the Up softkey.
This procedure causes all IP Phones to attempt firmware upgrade the next time
they connect to the GCD-CP10. This can make the upgrade procedure easier, as
it is not necessary to visit every telephone to perform the upgrade.
This can cause problems if, for example, a PoE (Power over Internet) switch is
used. When the PoE switch is powered up, all telephones connect to the FTP/
TFTP server at the same time. This causes a large amount of data for the FTP/
TFTP server to transfer over the data network.
To avoid this, connect the telephones to the PoE switch gradually, to allow time for
each telephone to upgrade before connecting the next.
To enable automatic upgrade:
When the IP phone boots up and connects to the SV9100 it receives download
information from the system that includes firmware information. When the SV9100
reports a version that is different than the version the IP phone is currently
utilizing, the IP phone will initiate the upgrade procedure.
Issue 2.0
IP Multiline Station (SIP)