NEC Univerge SV9100 Manual page 723

Hide thumbs Also See for Univerge SV9100:

Table of Contents

When entering names in the procedures below, refer to this chart. Names can have up to 12 digits.

Use this keypad digit . . .

When you want to. . .

Enter characters:

= Accepts an entry (only required if two letters on the same key are

needed - ex: TOM). Pressing

(In system programming mode, use the right arrow soft key instead to

accept and/or add a space.)

Clear the character entry one character at a time.

Clear all the entries from the point of the flashing cursor and to the

Conversion Table Number

Received Number

This is the received DID digits.

Target Number

Enter the destination number to which the

DID number is sent.

This is the name that is assigned to the

DID digits when it rings the extension.

Transfer Operation Mode

Key for Entering Names

again = Space.

Maximum eight digits

Maximum 24 digits

Maximum 12 characters

=No Transfer

=Busy/No Answer