NEC Univerge SV9100 Manual page 174

Issue 2.0
Program/
Description/Selection
Item No.
31-06-01 External Speaker Control –
Broadcast Splash Tone
before Paging (Paging Start
Tone)
31-06-02 External Speaker Control –
Broadcast Splash Tone
After Paging (Paging End
Time
31-06-03 External Speaker Control –
Speech Path
For Remote System
Program/
Description/Selection
Item No.
11-01-01 System Numbering
11-12-20 Service Code Setup (for
Service Access) – External
Paging
44-02-01 Dial Analysis Table for ARS/
F-Route Access) – Dial
44-02-02 Dial Analysis Table (ARS/F-
Route Access) – Service
Type
44-02-03 Dial Analysis Table (ARS/F-
Route Access) –Additional
data
SV9100 Networking Manual
Assigned Data
0 = No Tone Enable Splash Tone before paging.
1 = Splash Tone
2 = Chime Tone
Default is 2
0 = No Tone Enable Splash Tone after paging.
1 = Splash Tone
2 = Chime Tone
Default is 2
0 = Both Ways (Duplex) Establish whether or not the external speaker is
1 = One Way used for talkback.
PGD  SPK (Simplex)
(Not Available on CPU page port 9)
Default is 1
Assigned Data
Default is 51 = 2 digit: F- Assign also in PRG 11-12-20.
Route
Default is 703 Change 703 Setting based on the K-CCIS network
configuration.
Analysis Table 1 = 511 Assign the access code used to page.
Up to eight digits can be assigned.
Default is No Setting
0= No Setting (None) Assign Service Type.
1 = Extension Call (Own)
2 = ARS/F-Route Table
(F-Route)
3 = Dial Extension
Analyze Table
(Option)
Default is 0
0= No Setting For the Service Type selected in 44-02-02, enter
1 = Delete Digits 0~255 the additional data required.
(255: Delete All
Digits)
2 = 0~500
3 = Dial Extension
Analyze Table
Number (0~4)
Default is 0
Comments
Comments
4-95