NEC Univerge SV9100 Manual page 220

Issue 2.0
Program
/Item No.
44-05-01
44-05-02
44-05-03
44-05-04
44-05-05
44-05-06
44-05-07
44-05-08
44-05-09
44-05-10
SV9100 Networking Manual
Table 5-11 Open Numbering Plan Assignments (Continued)
Description/Selection
ARS/F-Route Table –
Trunk Group Number
ARS/F-Route Table –
Delete Digits
ARS/F-Route Table –
Additional Dial Number
Table
ARS/F-Route Table –
Beep Tone
ARS/F-Route Table –
Gain Table Number for
Internal Calls
ARS/F-Route Table –
Gain Table Number for
Tandem Connections
ARS/F-Route Table –
ARS Class of Service
ARS/F-Route Table – Dial
Treatment
ARS/F-Route Table –
Maximum Digit
ARS/F-Route Table –
CCIS over IP Destination
Point Code
Assigned Data
0-100,101-150,255
0 = Not Set
1~100 = Trunk Group from
PRG 14-05
101~150 = Networking
255 = Extension Call
Default is 0
0 = No Setting
1~255 = Number of digits to
delete
(255 = Delete All
Default is 0
0 = No Setting
0~1000
Add Digits in Program
44-06-01
Default is 0
0 = Off
1 = On
Default is 0
0 = No Setting
0 ~ 500
Default is 0
0 = No Setting
0 ~ 500
Default is 0
0 = No Setting
1 ~ 16
Default is 0
0 = No Setting
0 ~ 15
Default is 0
0 = No Maximum
0 ~ 24
Default is 0
0~16367 seconds
Default is 0
Comments
Select the trunk group to be used
for the outgoing K-CCIS call.
Enter the number of digits to be
deleted from the dialed number.
Select whether or not a beep is
heard if a lower priority trunk
group is used to dial out.
Select the gain table number to be
used for the internal call (defined
in Program 44-07).
Select the gain table number to be
used for the tandem call (defined
in Program 44-07).
Select the ARS Class of Service
to be used for the table. An
extensions ARS COS is
determined in Program 26-04-01.
If a Dial Treatment is selected,
Programs
44-05-02 and 44-05-03 are
ignored and the Dial Treatment
defined in Program 26-03-01 is
used instead.
Assign the Max Digits for K-CCIS
or ISDN Calls.
5-25