Class Of Service Options For Disa/E&M - NEC univerge SV9100 Programming Manual

Level:
IN
Description
Use Program 20-14 : Class of Service Options for DISA/E&M to enable/disable DISA and tie line
Class of Service options. You assign a DISA Class of Service to DISA users in Program 25-09. Assign
tie line Classes of Service in 34-02. Up to 15 DISA/E&M Classes of Service can be defined.
Analog trunk-to-analog trunk and ISDN trunk-to-ISDN trunk calls are supported by
this program. However, analog trunk-to-ISDN trunk and ISDN trunk-to-analog trunk
IMPORTANT
calls are NOT supported by this program.
Input Data
Class of Service Number
Item
No.
01 First Digit Absorbtion (Delete First Digit Dialed)
For tie lines, enable/disable the ability to absorb (ignore) the first
incoming digit. Use this to make the tie trunk compatible with 3-
and 4-digit tie line service. This option does not apply to DISA.
02 Trunk Group Routing/ARS Access
Enable/Disable a DISA or tie trunk caller ability to dial 9 for Trunk
Group Routing or Automatic Route Selection (ARS).
03 Trunk Group Access
Enable/Disable a DISA or tie trunk caller ability to access trunk
groups for outside calls (Service Code 704).
04
Outgoing System Speed Dial
Enable/Disable a DISA or tie trunk caller ability to use the System
Speed Dialing.
05
Operator Calling
Enable/Disable a DISA or tie trunk caller ability to dial 0 for the
telephone system operator.
2-276
Program 20 : System Option Setup
20-14 : Class of Service Options for DISA/E&M
Item
01~15
Default
Input
Data
COS 1~15
0 = Off 0
1 = On
0 = Off 1
1 = On
0 = Off 1
1 = On
0 = Off 0
1 = On
0 = Off 1
1 = On
Program 20 : System Option Setup
Issue 4.0