NEC univerge SV9100 Programming Manual page 243

Issue 4.0
Item
Item
No.
43 Video Mode
44
Using
Standard SIP
Display for
CPN
45
NAT Plug &
Play
46
Door Phone
Number
(Read Only)
47
Registration
Expire Timer
for NAT
SV9100 Programming Manual
Input Data
0 = Disable
1 = Enable
0 = Disable
1 = Enable
0 = Disable
1 = Enable
0 = Not assigned
1 ~ 8 = Door Phone No.
0 = Disable
60 ~ 65535(sec)
Default Description
0 This Program is used to
select the video function
with the standard SIP
terminal. If the standard
SIP terminal supports the
video function, the
SV9100 transfers the
video CODEC in SDP
information.
0 This Program is used to
Enable or Disable the
system to send INVITE
Fromtag Display attribute
which is sent from a
standard SIP terminal as
CPN to ISDN and if there
is no Display attribute
from standard SIP
terminal, the system will
not refer to either PRG
21-12-01 or 21-13-01 and
no CPN will be sent.
0 Select sending RTP port
number to remote router.
(0) uses result from
negotiation result, (1)
from received RTP
packet. Effective only
when 10-46-14 is to NAT
Mode.
0
Indicates automatically
assigned IP Door Phone
Number after system
registers the Door Phone
port. System assignes the
number not to duplicate with
the Door Phone connected
to 2PGDAD. (Read Only)
180
On a per station basis, this
setting defines the SIP
registration expiry timer. If
this value is set to 0, for a
NAPT terminal, the value in
PRG 84-23- 01 is applied.
Note: Version 9000 or higher
is required.
Related
Program
10-46-14
10-03
(DLCA)
PGD
10-46-14
2-203