Did Intercept Ring Group - NEC univerge SV9100 Programming Manual

Hide thumbs Also See for univerge SV9100:

Table of Contents

For each DID Translation Table, use

destination group for DID calls.

Depending on the entry in Program 22-09-02 and 22-11-04, the incoming calls route to the first

destination group by the following:

Vacant number intercept (vacant number means that no phone is connected, no station blade is

installed, or the extension number is not defined in Program 11-02)

Busy intercept

Ring-no-answer intercept

If the destination is 0, the calls are forwarded to the trunk ring group defined in Program 22-11 based on

the table assigned to the DID trunk.

If Programs 22-11-05 and 22-11-06 are set, the priority of transferring is in this order:

Program 22-11-05

For busy and no-answer calls, if the first and third destinations are programmed, but the

second destination is not, the incoming call goes to the third destination after the first

destination. If the first and second destinations are not defined, but the third destination

is, the call goes directly to the third destination.

Conversion Table Area Number

Day/Night Mode

Program 22 : Incoming Call Setup

22-12 : DID Intercept Ring Group

Program 22-12 : DID Intercept Ring Group

Program 22-11-06

Program 22-12.

Incoming Group Number

0 = No Setting

1~100 (Incoming Ring Group)

102 (In-Skin/External Voice Mail or InMail)

to define the first

Program 22 : Incoming Call Setup