Service Tone Timers - NEC univerge SV9100 Programming Manual

Level:
IN
Description
Use Program 20-18 : Service Tone Timers to set the values for the system service tone timers. Refer
to the following chart for a description of each option, its range and default setting.
Input Data
Item
Item
No.
01 Extension Dial Tone
Time
02
Busy Tone Timer
03
Congestion Tone
04 Call Waiting Tone Timer
05
Multiline Confirmation
Tone
06 Interval of Call Waiting
Tone
07 Intrusion Tone Repeat
Time
08
Conference Tone
Interval
09
Warning Beep Tone
Signaling Interval
2-284
Program 20 : System Option Setup
Input Data Default
0~64800 seconds
0~64800 seconds
0~64800 seconds
0~64800 seconds
0~64800 seconds
3~64800 seconds
0~64800 seconds
0~64800 seconds
0~64800 seconds

20-18 : Service Tone Timers

Description
30 After getting Intercom dial tone,
a telephone user has this time
to dial the first digit of the
Intercom call.
15
10
A Busy Tone when system
resources run short. (such as
DTMF receiver resources).
10 Sets the time between Call
Waiting tones. This timer also
sets the time between
Off-Hook Signaling alerts.
10
10
0 After a call is interrupted (such
as Barge-In, Voice Mail
Conversation Recording, or
Voice Over), the system
repeats the Intrusion Tone after
this time. Normally, you should
enter 0 to disable this time.
0
60
Program 20 : System Option Setup
Issue 4.0
Related
Program
14-01-18