Network Keep Alive Setup - NEC univerge SV9100 Programming Manual

Program 10 : System Configuration Setup
Level:
IN
Description
Use Program 10-31 : Network Keep Alive Setup to set the interval and retry count of the AspireNet
networking keep alive message. The keep alive is used for ISDN and IP networking.
The keep alive message is automatically responded to by the destination SV9100/UX5000, if the
response is not received the retry count will start. If a response is not received within the number of
retries, the networking link will be taken out of service. When the link is taken out of service:
Any calls that are in progress will be released.

Park Hold orbits will be released.

No further Park Hold information will be sent until the link is active.

The link will automatically become active when the next keep alive response is received.
Input Data
Item
Item
No.
01 Keep Alive Interval
This program is used to set the
interval of the Keep Alive timer.
The SV9100/UX5000 does not
send Keep Alive when this item
is set to 0. If this entry is greater
than 0, networked PRI spans
which are using Kentrox DSUs
will not re-sync when removed
from service, then returned to
service.
02
Keep Alive Retry Timer
Set how many times
theSV9100/ UX5000 resends
Keep Alive.
2-54

10-31 : Network Keep Alive Setup

Input Data
0~65535 seconds
1~255
Default
0
5
Program 10 : System Configuration Setup
Issue 4.0