Netlink Internet Protocol Address List Setting - NEC univerge SV9100 Programming Manual

51-03 : NetLink Internet Protocol Address List Setting

Level:
IN
Description
Use Program 51-03 : NetLink Internet Protocol Address List Setting to set the IP address of the
NetLink system.
Input Data
Item
No.
01
Internet Protocol Address List
The system seeks the Primary system based on this list.
When there is no Primary system yet, or Fail-Over occurs,
Node List is referred to establish new link. This setting is
necessary when PRG 51-01-03 is 0, or PRG 51-05-02 is other
than 0.
Once the system connects to the Primary System, this setting
is updated by the Primary system when PRG 51-13-01 is On.
So, enter IP address of the systems that may become Primary
at least.
Conditions
When there is no Primary System yet, or Fail Over occurs, Node List is referred to establish new link.

This setting is necessary when PRG 51-01-03 is 0, or PRG 51-05-02 is other than 0. Once the system

connects to the Primary System, this setting is updated by the Primary system when PRG 51-13-01 is
on. So, enter IP address of the systems that may become Primary at least.
Feature Cross Reference
None
2-652
Program 51 : NetLink Service
List ID
Item
1~50
Input Data
0.0.0.0 ~ 126.255.255.254
128.0.0.1 ~ 191.255.255.254
192.0.0.1 ~ 223.255.255.254
Program 51 : NetLink Service
Issue 4.0
Default
0.0.0.0