Netlink Communication Port Settings - NEC univerge SV9100 Programming Manual

Issue 4.0
Level:
IN
Description
Use Program 51-09 : NetLink Communication Port Settings to set the various communication ports
used on the system.
Input Data
Item
No.
01
Primary Waiting Port
Set the communication port that the Primary system uses to
communicate with the Secondary system.
02
Communication Waiting Port
Select port used to communicate between nodes. It is always opened
by all nodes.
03 Secondary Communication Port
Secondary system communicates with Primary system at this port
number. If 0 is specified, temporary port is dynamically selected.
04 Primary Search Port
When Fail-Over occurs, each system communicates with other system
at this port number.
If 0 is set, temporary port is dynamically selected.
If 0 is not specified, the number and continuous maximum 50 number is
used.
(Ex. 5000 is specified 5001, 5002...5049 are used).
05 Primary Detection Port
Enter port number to seek the Top Priority Primary system.
If 0 is specified, temporary port is dynamically selected.
06 Database Replication Communication Listening Port
Use this port to replicate database.
07
Database Replication Primary Detection Port Use
Use this port to replicate database.
If 0 is specified, temporary port is dynamically selected.
SV9100 Programming Manual
Program 51 : NetLink Service

51-09 : NetLink Communication Port Settings

Item Input Data Default
0~65535 58000
0~65535 58001
0~65535 0
0~65535 0
0~65535 0
0~65535 58002
0~65535 0
2-659