NEC univerge SV9100 Programming Manual page 206

Item
No.
07
DP to DTMF Conversion Options
Determine how a user can convert a
Dial Pulse (DP) call to a DTMF call. For
each trunk, set the type of DP to DTMF
conversion required. There are three
conversion options: Automatic (0),
Automatic and Manual (1), or Manual
(2).
Automatic:
DP to DTMF conversion occurs
automatically if the extension user
waits more than 10 seconds before
dialing the next digit.
Automatic and Manual:
DP to DTMF conversion occurs
automatically if the extension user
waits more than 10 seconds before
dialing the next digit. In addition, the
#
user can dial to switch a DP trunk to
DTMF dialing.
Manual:
#
Users can dial
to DTMF dialing.
08
Answering Condition
09
Busy Tone Detection
10
Caller ID
Enable/Disable ability of a trunk to
receive Caller ID information.
11
Next Trunk in Rotary if No Dial Tone
Enable/Disable the system ability to
skip over a trunk if dial tone is not
detected. This option pertains to calls
placed using Speed Dial, ARS, Last
Number Redial or Save Number
dialed. It does not pertain to line key or
Direct Trunk Access calls.
12 Detect Network Disconnect Signal
13 Trunk-to-Trunk Limitation
14 Loop Start/Ground Start
16 --- Not Used ---
2-166
Item
0 = Automatic
1 = Automatic and Manual
2 = Manual
to switch a DP trunk
0 = Polarity Reversing (Polarity)
1 = Polarity Reversing or Timer (Int Digit)
0 = Disable (No)
1 = Enable (Yes)
0 = No
1 = Yes
0 = Disable (No)
1 = Enable (Yes)
0
1
0
1
0 = Loop Start (Loop)
1 = Ground Start (Ground)
Input Data
= Disable (No)
= Enable (Yes)
= Disable (No)
= Enable (Yes)
Issue 4.0
Related
Default
Program
2 21-01-03
1 21-01-03
0
0
0
1
0
0
Program 14 : Trunk, Basic Setup