NEC univerge SV9100 Programming Manual page 30

1.
2.
S 3 H
ECTION OW TO
To enter programming mode:
1.
2.
3.
4.
5.
1-2
Enter the programming mode.
15-07-01
15-07-01 TEL
KY01 = *01

tells you to enter the programming mode, dial 150701 from the telephone dial
pad. After you do, you will see the message "15-07-01 TEL" on the first line of
the telephone display. This indicates the program number (15-07), item number
(01), and that the options are being set for the extension. The second row of the
display "KY01 = 01" indicates that Key 01 is being programmed with the entry

of 01. The third row allows you to move the cursor to the left or right,

depending on which arrow is pressed. To learn how to enter the programming
mode, refer to Section 3 How to Enter Programming Mode
E P
NTER ROGRAMMING
Go to any working display telephone.
In a newly installed system, use extension (port 1).
Do not lift the handset.
Press Speaker.
.
# #
 
Password
Dial the system password + Transfer.
Refer to the following table for the default system passwords. To change the
passwords, use 90-02 : Programming Password
M
ODE
Setup.
Issue 4.0
below.
Introduction