NEC univerge SV9100 Programming Manual page 832

Item
No.
20
Maximum non-MCU Video Channel Mode 1
Note when changing this PRG all DSP
resources are reset when idle. In progress calls
are not affected but until all DSP resources go
idle this change will not take affect.
Sets the number of VoIP DSP resources to
reserve for non-MCU mode 1 video. This
program is used if peer-to-peer is disabled for
standard SIP phones.
VoIP DSP resources are shared between video
and voice calls. The system will always keep 64
resources for voice calls. When changing this
program if resources are exceeded the system
will provide an error message and will not allow
the setting to be changed.
21 Maximum non-MCU Video Channel Mode 2
Note when changing this PRG all DSP
resources are reset when idle. In progress calls
are not affected but until all DSP resources go
idle this change will not take affect.
Sets the number of VoIP DSP resources to
reserve for non-MCU mode 2 video. This
program is used if peer-to-peer is disabled for
standard SIP phones.
VoIP DSP resources are shared between video
and voice calls. The system will always keep 64
resources for voice calls. When changing this
program if resources are exceeded the system
will provide an error message and will not allow
the setting to be changed.
22 Maximum MCU Group Number (Mode 1)
Note when changing this PRG all DSP
resources are reset when idle. In progress calls
are not affected but until all DSP resources go
idle this change will not take affect.
This setting reserves VoIP DSP resources for
mode 1 video conferences. When a DSP
resource is reserved it is not available for SIP
voice calls.
VoIP DSP resources are shared between video
and voice calls. The system will always keep 64
resources for voice calls. When changing this
program if resources are exceeded the system
will provide an error message and will not allow
the setting to be changed.
2-792
Item Input Data
0 ~ 8
0 ~ 6
0 = No MCU video channels
reserved.
1 = 4 MCU video Mode 1
channels reserved.
Program 84 : Hardware Setup for VoIP
Issue 4.0
Default
0
0
0