NEC univerge SV9100 Programming Manual page 619

Issue 4.0
Item
No.
08 Message Waiting Lamp
(Update MW Lamp)
Enable/Disable Message Waiting lamps at the
extension associated with the Subscriber mailbox.
For Subscriber Mailboxes, enable this option. For
Guest Mailboxes, disable this option.
09 Auto Attendant Direct to Voice Mail
(Auto-ATT DND)
Enable/Disable Auto Attendant Do Not Disturb.
When a subscriber enables Auto Attendant Do Not
Disturb, an Automated Attendant caller routes
directly to the mailbox, hears the greeting, and is
asked to leave a message. A subscriber also can
enable Auto Attendant Do Not Disturb while
recording their mailbox greeting.
10 Forced Unscreened Transfer
(Forced UTRF)
Enable/Disable Automated Attendant Forced
Unscreened Transfer for the Subscriber Mailbox. If
enabled, each Screened Transfer (TRF) to the
extension is converted to an Unscreened Transfer
(UTRF). If disabled, Screened Transfers from the
Automated Attendant occur normally.
11
Auto Time Stamp
Enable/Disable Auto Time Stamp for the Subscriber
Mailbox. If enabled, after the subscriber listens to a
message SV8100 InMail announces the time and
date the message was left. Auto Time Stamp also
announces the message sender (if known).
A subscriber also can enable Auto Time Stamp from
their mailbox.
12
System Administrator
Designate the Subscriber Mailbox as a System
Administrator. This allows the subscriber to use the
SA options after logging onto their mailbox.
13
Dialing Option
Provide additional dialing options for Next Call
Routing Mailbox calls (see Next Call Routing
Mailbox below). If enabled, a caller who accesses
the Subscriber Mailbox to leave a message can dial
any option in the Next Call Routing Mailbox Dial
Action Table. If disabled, the caller can dial only 0 (to
use the Next Call Routing Mailbox 0 action).
SV9100 Programming Manual
Item Input Data
0 = No (Disable)
1 = Yes (Enable)
0 = No (Disable)
1 = Yes (Enable)
0 = No (Disable)
1 = Yes (Enable)
0 = No (Disable)
1 = Yes (Enable)
0 = No (Disable)
1 = Yes (Enable)
0 = No (Disable)
1 = Yes (Enable)
Default
1
0
0
0
Mailbox 1 (101)=1
Other mailboxes=0
0
2-579