Control Using Fieldbus - ABB ACS800 Firmware Manual

146

Control using fieldbus

Name Description
Start/Stop Control Selecting the source for start and stop signals of the two
external control locations, EXT1 and EXT2
for EXT1
Selecting between EXT1 and EXT2
Defining Start/Stop selection
Defining the direction control
Selecting the DI for Slowdown
Selecting the signal for Fast Stop
Selecting the signal for the High-end limit
Selecting the signal for Low-end limit
Referencing EXT1
Selecting the source for the speed reference
Setting the reference limits
Setting the speed (frequency) limits
Setting the Slowdown reference
Setting acceleration and deceleration times
Referencing EXT2
Selecting the source for the speed/ torque reference
Setting the reference limits
Setting the speed (frequency) limits
Setting the Slowdown reference
Setting acceleration and deceleration times
Setting Joystick Warning delay
Communication
Setup
Setting the communication Interface
Setting the communication profile
Setting up the communication Adapter (If Adapter used)
Setting up the communication (If Standard Modbus used) group52
Application macros, control location EXT1/EXT2
Set parameters Parameter value
11.02 COMM.CW
10.01 COMM.CW
10.03 REQUEST
10.09 DI4
10.10
10.12
10.13
11.03 COMM.REF
11.04
11.05
20.02, 20.01, (20.08,
20.07)
11.12
22.02, 22.03, 22.10
11.06 COMM.REF
11.07
11.08
20.02, 20.01, (20.08,
20.07)
11.12
22.02, 22.03, 22.10
11.13 2 seconds
98.02
98.07
group51