ABB ACS800 Firmware Manual page 19

Select the motor control mode. The general parameter setting
procedure is given above.
DTC is suitable in most cases. The SCALAR control mode is recommended
- for multimotor drives when the number of the motors connected to the drive is
variable
- when the nominal current of the motor is less than 1/6 of the nominal current of
the inverter
- when the inverter is used for test purposes with no motor connected.
Enter the motor data from the motor nameplate:
3 motor
Hz
V
690 Y 50
400 D 50
660 Y
50
380 D
50
415 D 50
440 D
60
Cat. no
3GAA 202 001 - ADA
6312/C3
- motor nominal voltage
...
Allowed range: 1/2 · U
N
each of the nominal voltage ranges: 415 V AC for 400 V AC units, 500 V AC for
500 V AC units and 690 V AC for 600 V AC units.)
- motor nominal current
Allowed range: approx. 1/6 · I
99.04 = SCALAR))
- motor nominal frequency
...
Range: 8 300 Hz
- motor nominal speed
...
Range: 1 18000 rpm
-motor nominal power
...
Range: 0 9000 kW
ABB Motors
M2AA 200 MLA 4
IEC 200 M/L 55
No
Ins.cl. F
IP 55
IA/IN t E/s
kW
r/min A cos
30 1475 32.5 0.83
1475 56 0.83
30
1470 34 0.83
30
30 1470 59 0.83
30 1475 54 0.83
35 1770 59 0.83
6210/C3 180
IEC 34-1
2 · U of ACS800. (U refers to the highest voltage in
N N
...
2 · I of ACS800 (0 ... 2 · I
2hd 2hd
380 V
mains
voltage
if parameter
2hd
Start-up and control through the I/O interface
1 -> 0.0 rpm O
99 START-UP DATA
04 MOTOR CTRL MODE
[DTC]
Note: Set the motor data to
exactly the same value as
on the motor nameplate.
For example, if the motor
nominal speed is 1440 rpm
on the nameplate, setting
the value of parameter
99.08 MOTOR NOM
SPEED to 1500 rpm
results in the wrong
operation of the drive.
1 -> 0.0 rpm
99 START-UP DATA
05 MOTOR NOM VOLTAGE
[ ]
1 -> 0.0 rpm
99 START-UP DATA
06 MOTOR NOM CURRENT
[ ]
1 -> 0.0 rpm
99 START-UP DATA
07 MOTOR NOM FREQ
[ ]
1 -> 0.0 rpm
99 START-UP DATA
08 MOTOR NOM SPEED
[ ]
1 -> 0.0 rpm
99 START-UP DATA
09 MOTOR NOM POWER
[ ]
19
O
O
O
O
O