Drive Selection Mode; How To Select A Drive And Change Its Panel Link Id Number - ABB ACS800 Firmware Manual

50

Drive selection mode

In normal use, the features available in the Drive Selection Mode are not needed;
the features are reserved for applications where several drives are connected to one
panel link. (For more information, see the Installation and Start-up Guide for the
Panel Bus Connection Interface Module, NBCI, [3AFY58919748 (English)].
In the Drive Selection Mode, you can:
• View the device type, drive SW loading package name and ID number
• Select the drive with which the panel communicates through the panel link
• Change the identification number of a drive connected to the panel link
• View the status of the drives connected on the panel link.
The panel enters the Drive Selection Mode when you press the DRIVE key.
Each on-line station must have an individual identification number (ID). By default,
the ID number of the drive is 1.
Note: The default ID number setting of the drive should not be changed unless the
drive is to be connected to the panel link with other drives on-line.

How to select a drive and change its panel link ID number

Step Action
1. To enter the Drive Selection Mode.
2. To select the next drive/view.
The ID number of the station is changed by first pressing
ENTER (the brackets round the ID number appear) and
then adjusting the value with arrow buttons. The new value
is accepted with ENTER. The power of the drive must be
switched off to validate its new ID number setting.
The status display of all devices connected to the Panel
Link is shown after the last individual station. If all stations
do not fit on the display at once, press the double-arrow up
to view the rest of them.
3. To connect to the last displayed drive and to enter another
mode, press one of the mode selection keys.
The selected mode is entered.
Control panel
Press key
ACS800
DRIVE
AQCCXXXX xxxxxx
ID NUMBER 1
ACS800
AQCCXXXX xxxxxx
ID NUMBER 1
1o
Status Display Symbols:
= Drive stopped, direction
o
forward
= Drive running, direction
reverse
F = Drive tripped on a fault
1 L -> 1242.0 rpm I
FREQ
PAR
ACT
CURRENT
FUNC POWER
Display
45.00 Hz
80.00 A
75.00 %