Mitsubishi Electric FR-A820-00046 (0.4K) Instruction Manual page 105

Fr-a800 series
Hide thumbs Also See for FR-A820-00046 (0.4K):
Table of Contents

Advertisement

After making sure that the wiring is correct and secure, set "2" in Pr.30 Regenerative function selection. (Refer to
Three-phase
AC power
supply
*1
Remove jumpers across terminals R/L1 and R1/L11 as well as across terminals S/L2 and S1/L21, and connect the power supply for the control
circuit to terminals R1/L11 and S1/L21. Do not connect anything to power input terminals (R/L1, S/L2, and T/L3). Incorrect connection will damage
the inverter. (The E.OPT fault (option fault) occurs. (Refer to
*2
Do not install an MCCB across terminals P/+ and N/- (between terminals P/L+ and P/+ or between N/L- and N/-). Connecting the opposite polarity
of terminals N/- and P/+ will damage the inverter.
*3
Use Pr.178 to Pr.189 (Input terminal function selection) to assign the terminals used for the X10 signal. (Refer to
*4
Be sure to connect the power supply and terminals R/L11, S/L21, and T/MC1. Operating the inverter without connecting them will damage the
power regeneration common converter.
*5
Always connect terminal RDY on the FR-HC2 to a terminal where the X10 signal or MRS signal is assigned on the inverter. Always connect
terminal SE on the FR-HC2 to terminal SD on the inverter. Not connecting these terminals may damage the FR-CV.
NOTE
• The voltage phases of terminals R/L11, S/L21, and T/MC1 and the voltage phases of terminals R2/L1, S2/L2, and T2/L3 must
be matched.
• Use the sink logic (factory setting) when the FR-CV is connected. It cannot be connected when the source logic is selected.
• Do not connect a DC reactor (FR-HEL) to the inverter when the FR-CV is connected.
104
2. INSTALLATION AND WIRING
2.10 Connection of stand-alone option units
Dedicated stand-alone
reactor (FR-CVL)
MC1
MCCB
R/L11
S/L21
T/L31
FR-CV type
Power regeneration
common converter
R2/L12
R2/L1
S2/L22
S2/L2
P/L+
T2/L32
T2/L3
N/L-
P24
R/L11
SD
S/L21
∗4
RDYA
T/MC1
RDYB
RSO
SE
page
757.))
R/L1
U
S/L2
∗1
V
M
T/L3
W
R1/L11
S1/L21
Inverter
P/+
∗2
N/-
PC
SD
∗5
X10
∗3
RES
page
496.)
page
689.)

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Fr-a820-00167 (2.2k)Fr-a820-00046-gf (0.4k)Fr-a820-00250 (3.7k)Fr-a820-00105-gf (1.5k)Fr-a820-00077 (0.75k)Fr-a820-00250-gf (3.7k) ... Show all

Table of Contents