Mitsubishi Electric FR-A820-00046 (0.4K) Instruction Manual page 90

• When using an encoder cable (FR-JCBL, FR-V5CBL, etc.) dedicated to the conventional motor, the cables need to be
treated as the terminal block of the FR-A8AP is an insertion type. Cut the crimp terminal of the encoder cable and strip its
sheath to make its cable wires loose. Also, treat the shielding wires of the shielded twisted pair cable to ensure that they
do not contact conductive areas.
Wire the stripped cable after twisting it to prevent it from becoming loose. In addition, do not solder it.
NOTE
• Information on blade terminals
Commercially available products (as of January 2017)
Phoenix Contact Co., Ltd.
Terminal screw
size
M2
NICHIFU Co., Ltd.
Terminal screw
size
M2
• When using a blade terminal (without insulation sleeve), take caution that the twisted wires do not come out.
• Connection terminal compatibility table
Motor
Encoder cable
PA1
PA2
PB1
PB2
FR-A8AP terminal
PZ1
PZ2
PG
SD
Cable stripping size
5 mm
Ferrule terminal model
Cable gauge
With insulation
2
(mm )
sleeve
0.3 AI 0,34-6TQ
0.5 AI 0,5-6WH
Cable gauge Blade terminal
2
(mm ) product number
0.3 to 0.75 BT 0.75-7
SF-V5RU, SF-THY
FR-V7CBL
PA
Do not connect anything to this.
PB
Do not connect anything to this.
PZ
Do not connect anything to this.
PG
SD
Crimping tool
Without insulation
name
sleeve
A 0,34-7
CRIMPFOX 6
A 0,5-6
Insulation cap Crimping tool
product number product number
VC 0.75 NH 69
SF-JR/HR/JRCA/HRCA (with encoder)
FR-JCBL
PA
PAR
PB
PBR
PZ
PZR
5E
AG2
2. INSTALLATION AND WIRING
2.8 Connection to a motor with encoder (Vector control)
1
2
3
4
5
6
7
8
9
10
89