Mitsubishi Electric FR-A820-00046 (0.4K) Instruction Manual page 331

Pr.
656 to 659 (Analog remote output)
805 Torque command value (RAM)
806 Torque command value (RAM, EEPROM)
997 Fault initiation
*1 Writing during operation is disabled. To change the parameter setting value, stop the operation.
 Writing parameters during
operation(Pr.77 = "2")
• These parameters can always be written.
• The following parameters cannot be written during
operation if Pr.77 = "2". To change the parameter setting
value, stop the operation.
Pr.
Stall prevention operation level compensation
23
factor at double speed
48 Second stall prevention operation level
49 Second stall prevention operation frequency
60 Energy saving control selection
61 Reference current
Stall prevention operation reduction starting
66
frequency
71 Applied motor
79 Operation mode selection
80 Motor capacity
81 Number of motor poles
82 Motor excitation current
83 Rated motor voltage
84 Rated motor frequency
90 to 94 (Motor constant)
95 Online auto tuning selection
96 Auto tuning setting/status
135 to 139 (Electronic bypass sequence parameter)
178 to 196 (Input and output terminal function selection)
248 Self power management selection
254 Main circuit power OFF waiting time
261 Power failure stop selection
289 Inverter output terminal filter
291 Pulse train I/O selection
292 Automatic acceleration/deceleration
293 Acceleration/deceleration separate selection
298 Frequency search gain
313 to 322 (Extended output terminal function selection)
329 Digital input unit selection
373 Encoder position tuning setting/status
406 High resolution analog input selection
414 PLC function operation selection
415 Inverter operation lock mode setting
418 Extension output terminal filter
419 Position command source selection
420, 421 (Electronic gear)
450 Second applied motor
451 Second motor control method selection
453 Second motor capacity
454 Number of second motor poles
455 Second motor excitation current
456 Rated second motor voltage
457 Rated second motor frequency
458 to 462 (Second motor constant)
330
5. PARAMETERS
5.7 (E) Environment setting parameters
Name
Name
Pr.
463 Second motor auto tuning setting/status
541 Frequency command sign selection
560 Second frequency search gain
561 PTC thermistor protection level
570 Multiple rating setting
574 Second motor online auto tuning
598 Undervoltage level
Power failure stop external signal input
606
selection
639, 640 (Brake sequence)
641, 650, 651 (Second brake sequence)
660 to 662 Increased magnetic excitation deceleration
SF-PR slip amount adjustment operation
673
selection
699 Input terminal filter
702 Maximum motor frequency
706, 707, 711,
712, 717, 721, (PM motor tuning)
724, 725, 1412
738, 746, 1413 (Second PM motor tuning)
Second motor low-speed range torque
747
characteristic selection
Low speed range torque characteristic
788
selection
800 Control method selection
819 Easy gain tuning selection
858 Terminal 4 function assignment
859 Torque current/Rated PM motor current
Second motor torque current/Rated PM motor
860
current
862 Encoder option selection
868 Terminal 1 function assignment
977 Input voltage mode selection
998 PM parameter initialization
999 Automatic parameter setting
1002 Lq tuning target current adjustment coefficient
1103 Deceleration time at emergency stop
1105 Encoder magnetic pole position offset
1292 Position control terminal input selection
1293 Roll feeding mode selection
1348 P/PI control switchover frequency
Name