Copying And Verifying Parameters On The Operation Panel; Parameter Copy - Mitsubishi Electric FR-A820-00046 (0.4K) Instruction Manual

5.18
Copying and verifying parameters on the operation
panel
Pr.CPY setting value
0.---
1.RD
2.WR
3.VFY
NOTE
• When the copy destination is other than the FR-A800 series or when parameter copy is attempted after the parameter copy
reading was stopped, the model error "
• Refer to the parameter list on
• When the power is turned OFF or an operation panel is disconnected, etc. during parameter copy writing, write again or check
the setting values by parameter verification.
• When parameters are copied from a different-capacity inverter, there are parameters with different initial values depending on
the inverter capacity, so the setting values of some parameters will be automatically changed. After performing a parameter
copy from a different-capacity inverter, check all the parameter settings. (Refer to the parameter list
parameters with different initial values depending on individual inverter capacity.)
• While password protection is enabled, parameter copy and parameter verification cannot be performed. (Refer to
• If parameters are copied from an older inverter to a newer inverter that has additional parameters, out-of-range setting values
may be written in some parameters. In that case, those parameters operate as if they were set to initial values.

5.18.1 Parameter copy

• Inverter parameter settings can be copied to other inverters.
 Reading the parameter settings of the inverter to the operation panel
Operating procedure
1.
Connect the operation panel to the source inverter.
2.
Selecting the parameter setting mode
Press
3.
Selecting the parameter
Turn
"
4.
Reading to the operation panel
Turn
the operation panel. (It takes about 30 seconds to read all the settings. During reading, "
5.
End reading
"
NOTE
• "
708
5. PARAMETERS

5.18 Copying and verifying parameters on the operation panel

page 824
to choose the parameter setting mode. (The parameter number read previously appears.)
to " " (Parameter copy) and press
" appears.
to change the set value to "
" and " " are displayed alternately after settings are read.
" appears when a parameter read error occurred. Perform the operation from step 3 again.
Initial display
Copy the source parameters to the operation panel.
Write the parameters copied to the operation panel to the destination inverter.
Verify parameters in the inverter and operation panel. (Refer to
" appears.
for the availability of parameter copy.
". Press to start reading of the inverter parameter settings by
Description
(page
.
page 709.)
162) for details of
page 331.)
" blinks.)