Mitsubishi Electric FR-A820-00046 (0.4K) Instruction Manual page 576

• Switch the power voltage/current specifications of terminals 2 and 4 by Pr.73 Analog input selection or Pr.267 Terminal
4 input selection to match the specification of the input device. After changing the Pr.73 or Pr.267 settings, check the
voltage/current input selection switch. Incorrect setting may cause a fault, failure, or malfunction. (Refer to
the setting.)
Pr.128 Pr.609
setting Pr.610
0 PID invalid
10 Reverse action
11 Invalid Forward action
20 Reverse action
21 Forward action
40 to 43 Enabled Dancer control
50 Reverse action
51 Forward action
60 Reverse action
61 Forward action
70 Reverse action
71 Forward action
Invalid
80 Reverse action
81 Forward action
90 Reverse action
91 Forward action
100 Reverse action
101 Forward action
1000 Reverse action
1001 Forward action
1010 Reverse action
1011 Forward action
Reverse action (without
2000
frequency reflected)
Enabled
Forward action (without
2001
frequency reflected)
Reverse action (without
2010
frequency reflected)
Forward action (without
2011
frequency reflected)
*1 When Pr.133 ≠ "9999", the Pr.133 setting is valid.
*2 For the details of CC-Link/CC-Link IE field communication, refer to the Instruction Manual of the option FR-A8NC, FR-A8NCE.
*3 For the details of the PLC function, refer to the FR-A800 PLC Function Programming Manual.
• The set point/deviation input method can also be flexibly selected by Pr.609 PID set point/deviation input selection and
the measured value input method can be selected by Pr.610 PID measured value input selection. Selection by Pr.609
and Pr.610 is valid when Pr.128 = "1000 to 2011".
Pr.609 to Pr.610 settings
1
Terminal 1
2
Terminal 2
3
Terminal 4
4 CC-Link/CC-Link IE Field Network communication
5 PLC function
*4 When the same input method has been selected for the set point and measured value at Pr.609 and Pr.610, set point input is invalid. (Inverter
runs at set point 0%)
PID action Set point input
—
—
Terminal 2 or Pr.133
For details on dancer control, refer to
—
CC-Link/CC-Link IE Field
Network communication
—
PLC function
(with frequency applied)
—
PLC function
(without frequency
*3
applied)
According to Pr.609
—
According to Pr.609
—
Input method
*4
*4
*4
Measured value input
—
—
*1
Terminal 4
page 590.
—
CC-Link/CC-Link IE
Field Network
*2
*2
communication
—
PLC function
(with frequency
*3
*3
applied)
—
PLC function
(without frequency
*3
applied)
*1
According to Pr.610
—
*1
According to Pr.610
—
5.14 (A) Application parameters
1
page 473 for
2
Deviation input
—
Terminal 1
3
—
4
CC-Link/CC-Link IE
Field Network
*2
communication
5
—
PLC function
6
(with frequency
*3
applied)
—
7
PLC function
(without frequency
*3
applied)
8
—
9
—
According to Pr.609
10
—
According to Pr.609
575
5. PARAMETERS