Mitsubishi Electric FR-A820-00046 (0.4K) Instruction Manual page 711

4.
Selecting the parameter setting mode
Press
5.
Selecting the parameter
Turn
"
6.
Parameter verification
Turn
Press
verification destination inverter is started. (It takes about 60 seconds to verify all the settings. During verification,
"
● If there are different parameters, the different parameter number and "
● To continue verification, press
7.
"
NOTE
• When "
710
5. PARAMETERS
5.18 Copying and verifying parameters on the operation panel
to choose the parameter setting mode. (The parameter number read previously appears.)
to " " (Parameter copy) and press
" appears.
to change to setting value "
. Verification of the parameter settings copied to the operation panel and the parameter settings of the
" blinks.)
" and "
" blinks, the set frequency may be incorrect. To continue verification, press
" (Parameter copy verification mode).
.
" are displayed alternately after verification ends.
.
" are displayed alternately.
.