Table of Contents
Advertisement
2
3
4
5
6
7
8
Product manual - IRB 7600
3HAC022033-001 Revision: V
Action
Make sure the o-ring on the circumference
of the motor is seated properly. Lightly lub-
ricate the o-ring with grease.
Foundry Plus:
If the motor is a new spare part, the evacu-
ation hole protection filter must be replaced
with a transparent plug/sight glass (enclosed
with the spare part delivery). Remove the
protection filter and install the transparent
plug/sight glass.
xx1800000101
xx1800000102
Protection filter
Transparent plug
(Standard).
(Foundry Plus).
CAUTION
The motor weighs 22 kg! All lifting equip-
ment used must be sized accordingly!
Fit the lifting tool to the motor.
In order to release the brakes, connect the
24 VDC power supply.
Fit the two guide pins in two of the motor
attachment holes.
Fit the motor with guidance of the pins,
making sure the motor pinion is properly
mated to the gear of gearbox 4.
© Copyright 2007 - 2018 ABB. All rights reserved.
4.6.4 Replacement of motor, axis 4
Note
Art. no. is specified in
Required equip-
ment on page
331.
Tightening torque, transparent plug: 25
Nm ±10%.
Tightening torque, protection filter: 10 Nm
±10%.
xx1600000576
Choose the correct lifting tool:
•
lifting tool, motor axis 1, 4 and 5, if
the upper arm is positioned vertic-
ally
•
lifting tool, motor axis 2, 3 and 4, if
the upper arm is positioned hori-
zontally.
Art. no. is specified in
Required equip-
ment on page
331.
Connect to connector R2.MP4:
•
+: pin 2
•
-: pin 5
Art. no. is specified in
Required equip-
ment on page
331.
Shown in the figure
Location of motor on
page
331.
Make sure the motor pinion does not get
damaged!
Continues on next page
4 Repair
Continued
335
Advertisement
Table of Contents
