ABB IRB 7600 Series Product Manual page 341

Refitting, motor axis 5
The procedure below details how to refit the motor, axis 5.
1
2
3
4
5
6
7
8
9
10
11
Product manual - IRB 7600
3HAC022033-001 Revision: V
Action
DANGER
Turn off all:
• electric power supply to the robot
• hydraulic pressure supply to the robot
• air pressure supply to the robot
Before entering the robot working area.
Make sure the o-ring on the circumference of the
motor is seated properly. Lightly lubricate the o-ring
with grease.
CAUTION
The motor weighs 22 kg! All lifting equipment used
must be sized accordingly!
Fit the lifting tool, motor axis 1, 4, 5 to the motor.
In order to release the brakes, connect the 24 VDC
power supply to the motor.
Fit the two guide pins in two of the motor attach-
ment holes.
Fit the motor, with guidance from the pins, making
sure the motor pinion is properly mated to the gear
of gearbox, axis 5.
If necessary, use the rotation tool in order to rotate
the motor pinion when mating it to the gear!
Secure the motor with four attachment screws and
plain washers.
If required, use the extension 300 mm for bits 1/2". Art. no. is specified in
Disconnect the brake release voltage.
Reconnect all connectors beneath the motor cover.
© Copyright 2007 - 2018 ABB. All rights reserved.
4.6.5 Replacement of motor, axis 5
Note
Art. no. is specified in
equipment on page
Connect to connector R3.MP5
• +: pin 2
• -: pin 5
Art. no. is specified in
equipment on page
Make sure the motor pinion does
not get damaged!
Make sure the motor is turned the
right direction, that is the cables
facing forward.
Art. no. is specified in
equipment on page
xx0200000165
The rotation tool (A) is used be-
neath the motor cover, directly on
the motor shaft as shown in figure
above.
M10 x 40, 12.9 quality.
Tightening torque: 50 Nm.
equipment on page
Continues on next page
4 Repair
Continued
Required
338.
Required
338.
Required
338.
Required
338.
341