Field Network Parameters; Cc-Link Parameters - Mitsubishi Electric MELFA FR CR800 Series User Manual

13.7. Field Network Parameters

13.7.1. CC-Link parameters

This sets the CC-Link information in the robot controller.
Caution
This function can only be used with CR800-D/CR750-D/CRnD-700/CRn-500 series robot controller.
Set parameters while connected to the robot controller.
Double-click [Field network parameter] -> [CC-Link] under the [Parameter] item to be edited from the project tree.
After you change a parameter value, you can rewrite the parameters in the robot controller by clicking the [Write]
button.
CRnD-700 series robot controller
CRn-500 series robot controller
Figure 13-68 CC-Link parameter
You can reset CC-Link interface card errors by pressing the [Err. Cancel] button. After that the same error will not
occur. It is valid while the power supply of the Robot Controller is ON. When the power supply is turned OFF, the
error may occur again.
You can reference explanations of the displayed parameters by pressing the [Explain] button.
13-254 13-254