Ending Debugging - Mitsubishi Electric MELFA CR750 Series User Manual

8.9.6. Ending debugging

To end debugging, close the program with the "
opened in debugging status.
At this time, if the program has been changed, a confirmation message is displayed asking if you want to save
the changed contents.
Figure 8-58 Confirmation Message for Saving the Changed Contents
Here, if you select "No", the changed contents are all thrown out. To put the changed contents into effect,
always select "Yes".
8-134
" button at the upper-right of the edit screen for the program
Figure 8-57 Closing a Program Opened in Debug Status
This closes the program
opened in debugging status.
8-134