13.4.16.
Revision parameter editing
When you select "Edit the value of revision parameter directly" with "13.4.7 Revision parameter generation
procedure selection", this screen is displayed.
[Print]
[Reset]
Displays values of current revision parameters in the robot controller.
Select parameter from the list and double-click it to display the setting screen. Set the parameter values.
(If the CRn-500 series robot controller's version is older than J2, only the origin revision parameter (DJNT)
is shown.)
Click [Next] to write all parameters into the robot controller and proceed to "Re-start the Power Supply of
the Controller" window.
13-286
Figure 13-35 Edit Revision Parameters Window
Prints the revision parameter information displayed in the list.
Reset all changes.
Double click
13-286