Ethernet/Ip Parameter - Mitsubishi Electric MELFA CR750 Series User Manual

11.7.5. EtherNet/IP parameter

Set the information of EtherNet/IP in the robot controller. This function can be used with version 3.00A or later
of this software.
Caution
This function can only be used with CR750-D/CRnD-700 series robot controller. Also, this function
cannot be used with CR750-Q/CRnQ-700 series robot controller. If you use CR750-Q/CRnQ-700 series
robot controller, please set it with the software of the PLC.
Set parameters while connected to the robot controller.
From the project tree, double click the target project [Online] -> [Parameter] -> [Filed network parameter] ->
[EtherNet/IP].
After you change the parameter value, you can rewrite the parameter in the robot controller by clicking the
[Write] button.
You can copy network settings of the computer to the screen by clicking the [Copy PC network settings]
button.
You can reference explanation of displayed parameters by pressing the [Explain] button.
11-209
Figure 11-68 EtherNet/IP parameter
11-209