Stopping I/O Simulator - Mitsubishi Electric MELFA CR750 Series User Manual

During I/O simulator operating, the icon of I/O simulator is displayed in the task tray.
When the previously-used I/O simulator definition file exists, robot simulator and I/O simulator can start
simultaneously. Check the checkbox [Start I/O Simulator with the definition file used last] on the [Select the
project] screen which is displayed before starting the simulation.
Figure 19-14 Start robot simulator and I/O simulator simultaneously
During the simulation, the signal value of robots can be checked on the signal monitors. For details, refer to
"12.2.1 General signal" and "12.2.4 Register (CC-Link)". To check the signal value of device of GX
Simulator2, use GX Works2.
19.5.

Stopping I/O simulator

Click [Stop I/O simulator] button on toolbar or click the icon of I/O simulator on the task tray and select [Exit] to
stop I/O simulator during the simulation.
When the simulation stops and the connection status is offline, I/O simulator stops simultaneously.
19-446
Click the icon to open
menu.
Figure 19-13 Icon of I/O simulator
Stopping I/O simulator
Figure 19-15 Stopping I/O simulator
19-446