Mitsubishi Electric MELFA CR750 Series User Manual page 364

When the [Reflect to 3D monitor] check box is turned on, the joint position(FB) or the joint position(CMD)
which you selected by the cursor<b> is reflected to the 3D monitor.
By moving the cursor<b>, you can change the posture of the robot in the 3D monitor.
If the log data that you acquired from the robot have none of the joint position(FB) and the joint
position(CMD), you cannot turn on the [Reflect to 3D monitor] check box.
If the log data that you acquired from the robot have both the joint position(FB) and the joint position(CMD),
the joint position(FB) is reflected to the 3D monitor.
If the robot model displayed log data in the oscillograph screen do not match the robot model set in the
project, you cannot turn on the [Reflect to 3D monitor] check box. In this case, it is necessary to change the
robot model in the project to match the robot model set in the log data.
16-364
<b>
Figure 16-38 Operation of reflected to the 3D monitor
[Reflect to 3D monitor] check box
<a>
16-364