Mitsubishi Electric MELFA CR750 Series User Manual page 213
Hide thumbs
Also See for MELFA CR750 Series:
- Instruction manual (159 pages) ,
- Manual (2 pages) ,
- Ethernet function instruction manual (146 pages)
Table of Contents
Advertisement
It is possible to print only the parameter changed from initial value. This function can be used with Version 1.3
or later of this software. This function has the limitation in this software version and the software version of the
connected controller. Please refer to the table as follows.
Software version of
robot controller
After selecting "Changed" in View group on the Parameter list screen, click [Workspace] -> [Print] on the
menu bar. The screen for the print is displayed. Click [OK] button after confirming the printer. The print
is begun.
Moreover, you can see the print image by clicking [Workspace]->[Print Preview] on the menu bar.
11-213
Table 11-11 Compliant version of this function and controller
CR750-D/CRnD-700
Ver.P6 or later
Figure 11-72 Printing the parameter changed from initial value
Robot controller
CR750-Q/CRnQ-700
Ver.N6 or later
CRn-500
not use
11-213
Advertisement
Table of Contents
