17.5.
Program Execution
You can execute a program that has been opened in debugging status and that has been selected at
Operation panel.
Program selection
Program operation
Program starting condition
(*1) Do not finish the program that to run indefinitely automatically.
To forcibly stop a program that is executing, click the [Stop] button on the simulation operation screen.
17.6.
Specifying the Starting Line for Program Execution
You can freely specify the line in the program from which to start execution. Click [Jump] button on the
simulation operation screen. Input the step number to start execution from at "Jump" screen. The current
execution line moves to the specified step number.
Jump button
17-418
Table 17-5 the difference of program execution and debugging
Program execution
Use [Select] button on Operation panel
Use buttons on Operation panel
The conditions specified to slot table
Figure 17-59 Program Execution
Figure 17-60 Program Execution Line Execution
Program debugging
Open program by debugging mode
Use buttons on "Step"
Finish in 1 cycle (*1)
Select
Operation panel
Step
Jump screen
17-418