11.7.3. PROFINET parameter
Set the information of PROFINET in the robot controller. This function can be used with version 3.00A or later
of this software.
Caution
This function can only be used with CR750-D/CRnD-700 series robot controller. Also, this function
cannot be used with CR750-Q/CRnQ-700 series robot controller. If you use CR750-Q/CRnQ-700 series
robot controller, please set it with the software of the PLC.
Set parameters while connected to the robot controller.
From the project tree, double click the target project [Online] -> [Parameter] -> [Filed network parameter] ->
[PROFINET].
After you change the parameter value, you can rewrite the parameter in the robot controller by clicking the
[Write] button.
You can reference explanation of displayed parameters by pressing the [Explain] button.
When the PROFINET IO 2-Port module is mounted, in "Network base card information", contents of the option
card information are displayed. When the module is not mounted, nothing is displayed.
Figure 11-66 PROFINET parameter (Network base card information)
11-207
Figure 11-65 PROFINET parameter
11-207