Changing A Workspace - Mitsubishi Electric MELFA CR750 Series User Manual

5.7.

Changing a Workspace

It is possible to change directly the workspace with version 1.8 or later of this software.
When you use the software Version 3.20W or later, you can change the robot model of 3D monitor to the simple
model. Please refer to "12.1.5 3D Monitor" for the content of simple model.
Caution
Don't change the workspace name and the workspace title
Don't change the workspace name and the workspace title made with iQ Works(MELSOFT
Navigator). It becomes impossible to take the correspondence in iQ Works(MELSOFT Navigator) when
these information is changed.
Click the name of the workspace with the right button on the mouse, then click "Edit workspace" on the right
button menu. The "Change Workspace" screen is displayed, so input the new workspace name and new
workspace title, then click the [OK] button.
Figure 5-8 Changing the name of the workspace and workspace title
Once a workspace has been created, you can not directly change its name with version 1.7 or earlier of this
software. When you use this software of these version, to change a workspace name, use the menu bar
[Workspace] -> [Save As] to save the workspace with the desired new name, then delete the old workspace.
When the workspace title is changed, click the name of the workspace with the right button on the mouse,
then click "Edit workspace title" on the right button menu. The workspace title screen is displayed, so input the
new workspace title, and then click the [OK] button.
If you want to display robot model of the simple model in the 3D monitor, check the checkbox of same label.
5-63
made with iQ Works(MELSOFT Navigator).
5-63