Offline Editing Of Parameters; Compliant Version - Mitsubishi Electric MELFA CR750 Series User Manual

11.10.

Offline editing of parameters

It is possible to make newly the parameters of robot and preserve them in the file without connecting this
software to the robot controller. The file which read to the personal computer by the batch backup or the
parameter backup can be edited directly, and it can be edited by copying.
The file of these parameters edited by offline can be written to the robot controller by using the restoration
function.
This function can be used with the software Ver.1.4 or later. However, the function of restoring this
parameter file to the robot controller can be used with the software Ver.1.1 or later.
11.10.1.

Compliant version

The version of the robot controller and this software that corresponds to the offline editing of the
parameter is as follows.
1
2
3
1
2
Caution
Please use Ver.1.1 or later of this software,
It is possible to restore the parameters edited by offline in the function of backup/restore. The
robot controller might not operate correctly, if the parameters edited without connecting the robot
controller were restored with the software earlier than Ver.1.1. Please use this software Ver.1.1 or
later to restore the parameter edited without connecting the robot controller.
11-214
Table 11-12 Compliant version of the robot controller
Subject robot controller
CR750-D/CRnD-700 series
CR750-Q/CRnQ-700 series
CRn-500 series
Table 11-13 Compliant version of this software
Function
Offline editing
The parameter file made by the offline
editing is restored by the backup and
the restoration function.
if you restore the parameter edited by offline.
Compliant version
Ver.P6k or later
Ver.N6e or later
Ver.K9 or later
Version of RT ToolBox2
Ver.1.4 or later
Ver.1.1 or later
11-214