ABB ACSM1 Firmware Manual page 113

(1) INPUT
12.02 DIO2 CONF
Selects whether DIO2 is used as a digital input, as a digital output or as a frequency input.
(0) OUTPUT
(1) INPUT
(2) FREQ INPUT
12.03 DIO3 CONF
Selects whether DIO3 is used as a digital input, as a digital output or as a frequency output.
(0) OUTPUT
(1) INPUT
(2) FREQ OUTPUT
12.04 DIO1 OUT PTR
Selects a drive signal to be connected to digital output DIO1 (when
OUTPUT).
Bit pointer: Group, index and bit
12.05 DIO2 OUT PTR
Selects a drive signal to be connected to digital output DIO2 (when
OUTPUT).
Bit pointer: Group, index and bit
12.06 DIO3 OUT PTR
Selects a drive signal to be connected to digital output DIO3 (when
OUTPUT).
Bit pointer: Group, index and bit
12.07 DIO3 F OUT PTR
Selects a drive signal to be connected to frequency output (when
FREQ OUTPUT).
Value pointer: Group and index
12.08 DIO3 F MAX
Defines the maximum value for frequency output (when
OUTPUT).
3...32768 Hz
DIO1 is used as a digital input.
FW block: DIO2 (see above)
DIO2 is used as a digital output.
DIO2 is used as a digital input.
DIO2 is used as a frequency input.
FW block: DIO3 (see above)
DIO2 is used as a digital output.
DIO2 is used as a digital input.
DIO2 is used as a frequency output.
FW block: DIO1 (see above)
FW block: DIO2 (see above)
FW block: DIO3 (see above)
FW block: DIO3 (see above)
FW block: DIO3 (see above)
12.03 DIO3 CONF
Maximum DIO3 output frequency.
12.01 DIO1 CONF is set to
12.02 DIO2 CONF is set to
12.03 DIO3 CONF is set to
12.03 DIO3 CONF is set to
is set to (2) FREQ
Parameters and firmware blocks
113
(0)
(0)
(0)
(2)