ABB ACSM1 Firmware Manual page 286

286
Code Fault
(fieldbus code)
0307 DEFAULT FILE
(0x6100)
0308 APPL FILE PAR CONF
(0x6300)
0309 APPL LOADING
(0x6300)
0310 USERSET LOAD
(0xFF69)
0311 USERSET SAVE
(0xFF69)
0312 UFF OVERSIZE
(0x6300)
0313 UFF EOF
(0x6300)
0314 TECH LIB INTERFACE
(0x6100)
0315 RESTORE FILE
(0x630D)
0316 DAPS MISMATCH
(0x5484)
0317 SOLUTION FAULT
(0x6200)
Fault tracing
Cause
Drive internal fault
Note: This fault cannot be
reset.
Corrupted application file
Note: This fault cannot be
reset.
Corrupted application file
Note: This fault cannot be
reset.
Loading of user set is not
successfully completed
because:
- requested user set does not
exist
- user set is not compatible with
drive program
- drive has been switched off
during loading.
User set is not saved because
of memory corruption.
UFF file is too big.
UFF file structure failure
Incompatible firmware interface
Note: This fault cannot be
reset.
Restoration of backed-up
parameters failed.
Mismatch between JCU Control
Unit firmware and power unit
logic versions.
Fault generated by function
block SOLUTION_FAULT in the
application program.
What to do
Contact your local ABB representative.
Reload application.
If fault is still active, contact your local ABB
representative.
Reload application.
If fault is still active, contact your local ABB
representative.
Reload.
Check the setting of parameter
UNIT SUPPLY.
If the fault still occurs, contact your local ABB
representative.
Contact your local ABB representative.
Delete faulty file or contact your local ABB
representative.
Contact your local ABB representative.
Contact your local ABB representative.
Contact your local ABB representative.
Check the usage of the SOLUTION_FAULT
block in the application program.
95.01 CTRL