Group 52 Fba Data In - ABB ACSM1 Firmware Manual

Group 52 FBA DATA IN
These parameters select the data to be sent by the drive to the fieldbus controller,
and need to be set only if a fieldbus adapter module is installed. See also
A – Fieldbus control
Notes:
• This parameter group is presented in the User's Manual of the fieldbus adapter as
parameter group 3 or C.
• The new settings will take effect when the drive is powered up the next time
(before powering off the drive, wait at least 1 minute), or when parameter
FBA PAR REFRESH
• The maximum number of data words is protocol-dependent.
52
52 FBA DATA IN
52.01 FBA DATA IN1
Selects data to be transferred from the drive to the fieldbus controller.
0
4
5
6
14
15
16
101...9999
52.02 FBA DATA IN2
... ...
52.12 FBA DATA IN12
See
on page 385.
is activated.
52.01 FBA DATA IN1.
FW block: None
Not in use.
Status Word (16 bits).
Actual value 1 (16 bits).
Actual value 2 (16 bits).
Status Word (32 bits).
Actual value 1 (32 bits).
Actual value 2 (32 bits).
Parameter index.
FW block: None
FW block: None
Appendix
Parameters and firmware blocks
185
51.27