Mitsubishi Electric FR-A800 Series Instruction Manual page 23

Symbol
(a) Install the inverter.
(b) Perform wiring for the power supply and the motor.
Select the control method (V/F control, Advanced magnetic flux vector control, Vector control, or PM sensorless
(c)
vector control).
(d) Give the start command via communication.
(e) Give both the start and frequency commands from the PU. (PU operation mode)
Give the start command from the PU and the frequency command via terminals RH, RM, and RL. (External/PU
(f)
combined operation mode 2)
Give the start command from the PU and the frequency command by voltage input via terminal 2. (External/PU
(g)
combined operation mode 2)
Give the start command from the PU and the frequency command by current input via terminal 4. (External/PU
(h)
combined operation mode 2)
Give the start command via terminal STF or STR and the frequency command from the PU. (External/PU
(i)
combined operation mode 1)
Give the start command via terminal STF or STR and the frequency command via terminals RH, RM, and RL.
(j)
(External operation mode)
Give the start command via terminal STF or STR and the frequency command by voltage input via terminal 2.
(k)
(External operation mode)
Give the start command via terminal STF or STR and the frequency command by current input via terminal 4.
(l)
(External operation mode)
22
1. INTRODUCTION
1.3 Operation steps
Downloaded from ManualsNet.com search engine
Overview Refer to page
37
55
221
659
149
151
152
153
155
156
157
160